urethane mounts

[Biggs]

where would you get this shore 90A urethane at, and hwo long does it take to dry? like a week?

[Ovaltine Jenkins]

you gotta get it online, and if you do it, the mounts should not be supporting the engine, they would need to be taken out and left somewhere to cure for at least a week.

[Biggs]

i can use this to like patch up mounts that are almost like broken right?

[Ovaltine Jenkins]

yeah, but you might as well just remove the old rubber and put in new urethane.

[Biggs]

if i were to remove the old rubber, how can i be certain that the hole of the screw is in the right place.

[Ovaltine Jenkins]

well, the metal sleeve is right in the middle, isn't it? Hold the sleeve in the middle, pour the urethane, hold the sleeve or make something to hold it in place, and that's it.

[Biggs]

do you know exactly where i can get this urethane stuff at? Might do my shifter bushing too

[Ovaltine Jenkins]

just google it, I looked for it a few months ago but forgot the sites.

[Brian]

McMaster-Carr

[aznsap]

Shore A 80 urethane (part # 8644K11) purchased from www.mcmaster.com

http://www.cardomain.com/ride/352601/8

i did my 2 motor mounts and my tranny mount. i wish i had done my shifter bushing too but didn't think about it at the time.

[Ovaltine Jenkins]

ur supposed to use shore 90 for mounts, aren't you? I know I almost ordered shore 90 a after doing research.

[Biggs]

woah awesome!!! So could i use hte 94 or is that gonna be too stiff??

[Ovaltine Jenkins]

too stiff
................

[aznsap]

i guess you can go w/ shore 90, the 80 stuff is already considerably stiffer than stock.

[Biggs]

i don't see 90 all i see is 94

[walec05]

hey, its up to you. if you want to go 94 then go for it, but like said above its alot stiffer.

[mjk]

hey azn, did what you did improve wheel hop?